Filter
Top Products
110
Troubleshooting
If you suspect a malfunction, please check the following points. If this does not resolve the problem,
contact a nearby Roland Service Center.
Power Supply
Problem
Cause and Action
See
Page
The power does not turn
on when you move the
[POWER] switch to the
“ON” position.
●
Could you be using an AC adaptor other than the included one?
➔
Use included dedicated AC adaptor.
21
●
Could the AC adaptor plug have been disconnected from the CD-2e’s
AC adaptor jack? Could the power cord have been disconnected from
the AC outlet or the dedicated AC adaptor’s connector?
➔
Firmly reconnect the dedicated AC adaptor and power cord.
21
●
Could the remaining battery power be insufficient?
➔
Once the battery runs low, the power may not turn on. Install fresh
batteries.
23
●
Are the batteries installed in the correct orientation?
➔
Check the “ ” and “ ” orientation of the batteries, and install them
correctly.
22
Screen
Problem
Cause and Action
See
Page
The screen is difficult to
read
●
Depending on the location or environment in which the CD-2e is
placed, the screen may be difficult to read.
➔
Readjust the display contrast.
95
The screen goes dark
●
If you’re using batteries, the Backlight Timer setting will dim the
screen when you haven’t operated the CD-2e for a specified length of
time.
➔
Turn the Backlight Timer “Off.”
96
Unreadable characters
appear on the screen
●
Could you have specified the wrong screen display language?
➔
Select the appropriate screen display language.
97
CD-2e_e.book 110 ページ ２００７年９月１０日 月曜日 午後８時５７分