Roland CD-2e CD Player User Manual


 
44
Recording a Cassette or MD
Here’s how to record the sound from a cassette or MD.
4
Connect your audio device (e.g., cassette deck) to the CD-2e’s LINE IN
jacks.
Use audio cables to connect the CD-2e’s LINE IN jacks to the output jacks of your audio
device (e.g., cassette deck).
fig.connect-record-e.eps
5
Turn the [LINE] knob to adjust the input level at the LINE IN jacks.
Adjust the loudness of the sound you’re recording. Since you’re not using the mic input,
set the [MIC LEVEL] switch to the “MANUAL” position, and then turn the [MIC] knob all
the way to the left (off).
While playing the song to be recorded, turn the [LINE] knob to adjust the input level.
Adjust the level so that the peak indicator located above the [LINE] knob lights briefly
during the loudest passages of the song that’s being recorded.
fig.rec-line-e.eps
If you’re recording to an SD
memory card
If you’re recording to a
CD-R/RW disc
1
Turn on the power.
(
Page 21, 22)
1
Turn on the power.
(
Page 21)
2
Insert the SD memory card.
(
Page 24)
2
Insert the CD.
(
Page 27)
3
Set the audio source to “SD.”
Press the [SD CARD] button so it’s lit.
fig.selectCD-e.eps
3
Set the audio source to “CD.”
Press the [CD] button so it’s lit.
fig.selectSD-e.eps
To the output jacks of
the audio device (amp)
CD-2e: RCA phono type
Audio device: RCA phono type
* Portable players use a stereo mini type jack
Types of plugs that can be connected
RL
LouderQuieter
At this position
Peak indicator
The level meter will move according
to the level of the audio input.
CD-2e_e.book 44 ページ 2007年9月10日 月曜日 午後8時57分