Filter
Top Products
Panel Descriptions
(continued)
17
Advanced UsesRecording Listening Deleting Creating a CD Editing an SD Appendices
Convenient
Functions
Information
/ Display
Checking /
Preparations
fig.unit02-e.eps
LINE IN Jacks
Connect an electronic piano, keyboard, cassette
deck, etc. to these jacks.
☞
“Recording an Electronic Instrument” (Page 42),
“Recording a Cassette or MD” (Page 44)
EXT MIC Jacks (R jack, L/MONO jack)
Connect external mics to these jacks.
If you’re using only one mic, connect it to the L/
MONO jack.
☞
“Connecting an External Mic for Recording” (Page 39)
Grounding Terminal
Connect this to an external electrical ground.
[MIC SELECT] Switch
This selects the mic(s) to be used for recording.
☞
“Recording with the Internal Mics” (Page 36),
“Connecting an External Mic for Recording” (Page 39)
[MIC LEVEL] Switch
This selects how the mic input level is to be
adjusted.
☞
“Recording Acoustic Instruments or Vocals” (Page 36),
“Adjusting the Input Level Automatically (Auto Level
Function)” (Page 38)
SD Card Slot
You can insert an SD memory card here.
☞
“Preparing an SD Memory Card” (Page 24)
PHONES Jack
You can connect a set of headphones to this jack.
* If headphones are connected, there will be no sound
from the speakers.
☞
Step 4 on “Recording with the Internal Mics” (Page
36)
Side Panel
Depending on the circumstances of a particular setup,
you may experience a discomforting sensation, or
perceive that the surface feels gritty to the touch when
you touch this device, microphones connected to it,
or the metal portions of other objects, such as guitars.
This is due to an infinitesimal electrical charge, which
is absolutely harmless. However, if you are concerned
about this, connect the ground terminal (see figure)
with an external ground. When the unit is grounded,
a slight hum may occur, depending on the particulars
of your installation. If you are unsure of the connection
method, contact the nearest Roland Service Center, or
an authorized Roland distributor, as listed on the
“Information” page
Unsuitable places for connection
●
Water pipes (may result in shock or electrocution)
●
Gas pipes (may result in fire or explosion)
●
Telephone-line ground or lightning rod (may be
dangerous in the event of lightning)
Switch setting
Explanation
INT (internal)
Record using the internal mics.
EXT (external) Record using an external mic.
Switch
position
Explanation
MANUAL
The [MIC] knob will adjust the mic’s
input level.
AUTO The mic input level will be adjusted
automatically. Operating the [MIC]
knob will not affect the input level.
CD-2e_e.book 17 ページ ２００７年９月１０日 月曜日 午後８時５７分