Filter
Top Products
39
Recording to CF/CD
“Pan” refers to the left/right position of the sound. On the
CD-2, the pan of the mics connected to the MIC1 and MIC2
jacks can be set to left, right, or center.
When using two mics to record a lecture or band performance,
you can set the pan to left and right so that the natural
spaciousness of the sound is captured (i.e., stereo recording).
1
Press until “Ext MIC1/2 Pan” appears
in the display, and then press .
• You can also select this item by turning [DATA].
The following screen appears.
2
Turn to select how MIC 1 and MIC 2
are to be panned.
• Normally, you should choose “C/C” when
recording a solo performer. You should also choose
“C/C” if you’re recording from a single mic.
Choose “L/R” when recording a band
performance or a lecture.
3
Press twice.
You’re returned to the previous readout.
When you record via the internal mics, the left and right
channels of the recorded sound may be perceived as not being
balanced, depending on the location in which the CD-2 is
placed.
For example, if the CD-2 has been placed at an angle relative
to the audio source you’re recording, the sound from the mic
that is closer to the audio source will sound louder.
You can adjust the left/right volume balance of the internal
mics as appropriate for the location in which the CD-2 is
placed.
1
Press until “Int MIC Bal” appears in
the display, and then press .
• You can also select this item by turning [DATA].
The following screen appears.
2
While making sound, adjust the volume
balance of the L and R channels.
Adjust the volume balance so that the L and R meters
show approximately the same level.
• You can adjust the balance from L50–R50. The
center position (C) indicates that both microphones
will pick up sound at equal level.
When set to L50, no sound will be picked up by the
R channel mic. When set to R50, no sound will be
picked up by the L channel mic.
3
Press twice.
You’re returned to the previous readout.
When Recording from
Connected Mics (Pan Setting)
MIC 1 MIC 2
L/R Left Right
C/C Center Center
R/L Right Left
L/C Left Center
R/C Right Center
C/L Center Left
C/R Center Right
Adjusting the Left/Right Volume
Balance of the Internal Mics
CHECK
Make sure that [MIC SELECT] is lit green.
Page 37
Settings for Recording (continued)