Filter
Top Products
16
Panel Descriptions (continued)
Introduction
POWER Switch
This turns the power on/off.
Page 24, “Turning the Power On/Off”
AC Adaptor Jack
Connect the included AC adaptor to this jack.
Page 20, “Connecting Other Equipment”
Cord Hook
Wrap the AC power adaptor cord around this hook to
prevent the cord from being accidentally unplugged.
Page 21, “Caution when making connections: AC
Adaptor Jack”
FOOT SW (Foot Switch) Jack
You can connect a foot switch (such as the Roland DP-2 or
BOSS FS-5U; separately available) to this jack. Use it to
play back, record, or assign track numbers.
Page 20, “Connecting Other Equipment”
Page 76, “Specifying the Function of the Foot Switch”
MIDI OUT Connector
This connector transmits MIDI messages.
● If you want to play back SMF (Standard MIDI File)
data, connect this jack to the MIDI IN connector of
your external sound generating device.
Page 73, “Playing SMF (Standard MIDI File) Data”
AUX OUT Jacks
Use these jacks to output analog audio signals to an
external speaker system or electronic piano.
Page 20, “Connecting Other Equipment”
You can choose the type of audio signal that is sent from
the AUX OUT jacks.
Page 77, “Choosing the Audio Source that is Output
from the AUX OUT Jacks”
LINE IN Jacks
You can connect your electronic piano or keyboard to
these jacks, and record your performance.
Page 20, “Connecting Other Equipment”
LEVEL Knob
This knob adjusts the input level of the LINE IN jacks.
Page 38, “Adjusting the Input Level”
Grounding Turminal
Connect a ground cable here.
NOTE
• Depending on the circumstances of a particular setup,
you may experience a discomforting sensation, or
perceive that the surface feels gritty to the touch when
you touch this device, microphones connected to it, or
the metal portions of other objects, such as guitars.
This is due to an infinitesimal electrical charge, which is
absolutely harmless. However, if you are concerned
about this, connect the ground terminal with an external
ground. When the unit is grounded, a slight hum may
occur, depending on the particulars of your installation.
If you are unsure of the connection method, contact the
nearest Roland Service Center, or an authorized Roland
distributor, as listed on the “Information” Page 94.
Unsuitable places for connection
- Water pipes (may result in shock or electrocution)
- Gas pipes (may result in fire or explosion)
- Telephone-line ground or lightning rod (may be
dangerous in the event of lightning)
Rear Panel