Filter
Top Products
38
Settings for Recording (continued)
Recording to CF/CD
Here’s how to adjust the input level of the input jacks (MIC 1/
MIC 2/GUITAR/LINE IN jacks) to which you’ve connected
mics or instruments.
1
While you listen to the sound, turn the
appropriate level knob to adjust the input
level.
The different input jacks are controlled by the
following level knobs.
POINT
POINT
For best results, adjust the level so that the level meter
briefly reaches “-3 dB” when you play strongly or
speak loudly.
MEMO
• Adjust [OUTPUT LEVEL] so that you can comfortably
listen to the connected instrument or mic. Adjusting this
volume will not affect the sound (input level) that’s
being recorded. Page 25, “Adjusting the Volume”
If you’re playing back a music CD or CF card while recording
an additional vocal or instrument “layered” onto it ( Page
32, 34), you may need to adjust the volume of the music CD or
CF card to create the correct balance.
In such cases, you can adjust the playback level of the music
CD or CF card to create the desired balance.
1
Press for the media (CD or CF)
whose playback level you want to adjust.
2
Turn to adjust the playback level.
When you turn [DATA], the playback level of the
music CD or CF card is displayed.
• You can adjust the level in a range of -50– +25.
• A setting of “0” is the original playback level.
POINT
POINT
For best results, adjust the level so that the level meter
briefly reaches “-3 dB” when the sound from the music
CD or CF card is mixed with the sound of the mic or
instrument.
3
When you’ve finished adjusting the
playback level, press .
• Press the button for the media (CF card or CD)
you’re playing.
• If you do not operate the [DATA] dial for five
seconds, you will be automatically returned to the
previous readout.
MEMO
• Noise may occur if you adjust the playback level during
playback. This is normal and does not indicate a
malfunction.
• The playback level setting you adjust here is temporary,
and will be cleared when you turn off the power. It will
be returned the original playback level the next time you
turn on the power. If you want to keep the playback
level setting, make settings as described in Page 79,
“Adjusting the Playback Level of a Music CD/CF Card.”
Adjusting the Input Level (continued)
MIC 1/MIC 2/GUITAR/LINE IN Jacks
CHECK
Make sure that [MIC SELECT] is lit orange.
Page 37
* If you want to record only from a device
connected to the LINE IN jacks, make
sure that [MIC SELECT] is not lighted.
Jack name Level knob
MIC 1
GUITAR
* Front panel
MIC 2
* Front panel
LINE IN
* Rear panel
MIN MAX
“-3dB”
Temporarily Adjusting the Playback
Level of a Music CD or CF Card
“CF Mix Level”
when using a CF card
“-3dB”