Filter
Top Products
22
Connecting Other Equipment (continued)
Introduction
If you’re using condenser mics, you must make settings so
that phantom power is supplied to them.
NOTE
• Supplying phantom power to a dynamic mic or an audio
playback device will cause malfunctions. Also, the CD-2
cannot be used with devices other than condenser mics
that require phantom power (such as the BOSS Direct
Box DI-1).
Carefully read the owner’s manual for the mic you’re
using, and be sure to set the phantom power switch
to “OFF” unless you are using a condenser mic that
requires phantom power.
1
Connecting a mic to the XLR type MIC 1
(or MIC 2) jack
MEMO
• Phantom power is not supplied to the phone type MIC 1
jack and MIC 2 jack located on the front panel. If your
mic requires phantom power, you must connect the mic
to the XLR type MIC 1 jack (or MIC 2 jack) located on the
side panel.
2
Turn on the power of the CD-2.
Page 24, “Turning the Power On”
3
Slide the phantom power switch located
on the side panel toward the right to the
“ON” position.
Connecting Condenser Mics
Phantom power switch