Filter
Top Products
83
Advanced UsesRecording Listening Deleting Creating a CD Editing an SD Appendices
Convenient
Functions
Information
/ Display
Checking /
Preparations
Sounding the Metronome
The CD-2i has built-in metronome—a convenient feature for practicing an instrument.
1
Press the [ ](Metronome) button to turn the metronome on.
The setting will turn on/off each time you press the
[]
(Metronome)
button.
* Whenever the unit has remained inactive for a predetermined amount of time, it will go back to
displaying the Source (Sound Source) screen.
fig.metro-indicator-e.eps
If the metronome is on, the [ ](Metronome) button will light. At the same time, the
metronome’s indicator will start blinking on the beat.
When you press the [ ](Metronome) button once again, the metronome will turn off
(unlit).
2
Setting the sound.
fig.menu-metro01-e.eps
Press the [
]
(Metronome)
button to access the
menu screen.
Use the [ ] buttons to choose “Sound.”
Use the [+] [-] buttons to select the desired metronome
sound.
3
Setting the tempo.
fig.menu-metro03-e.eps
Use the [ ] [ ] buttons to choose “Tempo.”
Specify the tempo of the metronome
•Use the [+] [-] buttons to change the tempo value.
•Specify the desired tempo by tapping it out using
the [ENTER] button.
Value
Explanation
Silent
There will be no sound; the metronome indicator will blink to mark the
beats.
Bell (factory setting) A bell will mark the beats.
Click An electronic sound will mark the beats.
Voice A human voice (English) will count the beats
Value
Explanation
=20–120 (factory setting)–250
Specifies the number of quarter-notes in one minute.
Decreasing this value will make the tempo slower. Increasing
this value will make the tempo faster.
Metronome indicator (blinking)
Red: strong beats
Green: weak beats
CD-2i_e.book 83 ページ ２０１０年３月１５日 月曜日 午前１０時１５分