Filter
Top Products
16
Panel Descriptions
(continued)
fig.unit02-e.eps
CD Tray
This is where you insert a CD.
☞
“Inserting a CD” (Page 28)
Emergency Eject Hole
You can use this to remove the CD in case of
emergency. Normally, it is not used.
☞
“If You are Unable to Eject the Disc” (Page 29)
fig.unit02-e.eps
EXT MIC Jacks (XLR type, MONO jack)
Connect external mics to these jacks.
This connector can supply phantom power.
☞
“Connecting an External Mic for Recording” (Page 44)
* This instrument is equipped with balanced (XLR) type
jacks. Wiring diagrams for these jacks are shown below.
Make connections after first checking the wiring
diagrams of other equipment you intend to connect.
EXT MIC Jacks (R jack, L/MONO jack)
Connect external mics to these jacks.
If you’re using only one mic, connect it to the L/
MONO jack.
☞
“Connecting an External Mic for Recording” (Page 44)
Ground Terminal
Connect this to an external electrical ground.
Right Side Panel
Left Side Panel
Depending on the circumstances of a particular setup,
you may experience a discomforting sensation, or
perceive that the surface feels gritty to the touch when
you touch this device, microphones connected to it,
or the metal portions of other objects, such as guitars.
This is due to an infinitesimal electrical charge, which
is absolutely harmless. However, if you are concerned
about this, connect the ground terminal (see figure)
with an external ground. When the unit is grounded,
a slight hum may occur, depending on the particulars
of your installation. If you are unsure of the connection
method, contact the nearest Roland Service Center, or
an authorized Roland distributor, as listed on the
“Information” page
Unsuitable places for connection
●
Water pipes (may result in shock or electrocution)
●
Gas pipes (may result in fire or explosion)
●
Telephone-line ground or lightning rod (may be
dangerous in the event of lightning)
CD-2i_e.book 16 ページ ２０１０年３月１５日 月曜日 午前１０時１５分