Filter
Top Products
30
Preparing the Remote Control
When shipped from the factory, a coin-type lithium battery is installed in the remote
control unit. To start using the remote control unit, simply pull out the insulating sheet
that extends from the battery compartment.
Install a coin-type
lithium
battery in the remote control.
fig.remote01-e.eps
* Use only the specified type (model no.CR2025) of lithium battery. Be sure to insert it as
directed to ensure correct polarity.
1
Pull out the battery holder.
2
Insert a lithium battery (CR2025) as shown in the illustration.
3
Replace the battery holder.
Push it inward until it clicks into place.
Point the remote control toward the CD-2i’s sensor, and operate it within the specified
operating range.
When the remote sensor detects a remote control operation, the [ENTER] button will
blink.
fig.remote02-e.eps
* Even if the remote control is within range, it may not work if there is an obstruction between it
and the remote sensor, or if the angle is excessive.
* The battery life will depend on the conditions of use. When the battery runs down, the operating
angle will become narrower. Replace the battery if this occurs.
* If you won’t be using the remote control for an extended period of time, remove the battery.
* If a spotlight or other strong light is directed at the remote sensor, it will be less responsive.
Replacing the Remote Control’s Battery
Using the Remote Control
Back side of the
remote control
1
2
Battery holder
Press here in the direction of the
arrow while you pull out the holder.
Batteries to use:
Lithium battery
(CR2025)
Remote control operating range
Distance: 5 meters
Angle: 45 degrees or less
Remote sensor
Transmitter
CD-2i_e.book 30 ページ ２０１０年３月１５日 月曜日 午前１０時１５分