Filter
Top Products
50
Recording an Electronic Instrument
(continued)
6
Turn the [LINE/PHONO] knob to adjust the input level at the LINE/
PHONO IN jacks.
Adjust the loudness of the sound you’re recording. Since you’re not using the mic input,
set the [MIC LEVEL] switch to the “MANUAL” position, and then turn the [MIC] knob all
the way to the left (off).
While producing the sound that you will actually be recording, turn the [LINE/PHONO]
knob to adjust the input level.
Adjust the level so that the PEAK indicator located above the [LINE/PHONO] knob lights
briefly at the loudest moments of the performance you’ll be recording.
* When using the [MIC] knob or [LINE/PHONO] knob, you might hear a slight noise when the
recording level changes; this does not indicate a malfunction.
fig.rec-line-e.eps
7
Press the [ ](Record) button to enter recording-standby mode.
fig.rec-intmic04-e.eps
8
Press the [ ](Play) button to begin recording.
Start your performance.
fig.rec-intmic05-e.eps
9
Press the [ ](Stop) button to stop recording.
fig.rec-intmic06-e.eps
The recorded song will be added to the end of the SD memory card or CD-R/RW disc.
If you want to listen to the song you recorded, press the [ ](Play) button
immediately after you stop recording.
LouderQuieter
At this position
PEAK indicator
The level meter will move according
to the level of the audio input.
Blinking
Remote control
Lit
Remote control
Remote control
CD-2i_e.book 50 ページ ２０１０年３月１５日 月曜日 午前１０時１５分