When connecting with optional
CD-IU201S cable
This product
1.5 m (4 ft. 11 in.)
Dock connector
USB cable
(Supplied with this unit)
Connect to separately sold
USB device.
USB/iPod input
iPod with video
capabilities
(sold separately)
RGB input
Interface cable
(CD-IU201S) (sold separately)
Notes
! Checkall connections andsystems before
final installation.
! Donot use unauthorizedparts as this may
cause malfunctions.
! Consultyour dealer ifinstallation requires
drilling of holesor other modifications to the
vehicle.
! Donot install thisunit where:
— itmay interfere with operationof the vehicle.
— itmay cause injury toa passengeras a result
of asudden stop.
! Thesemiconductor laser will bedamaged if
it overheats. Installthis unit away from hot
places such as nearthe heater outlet.
! Optimumperformance is obtained when the
unit is installedat an angle of less than30°.
! Wheninstalling, to ensureproper heat dis-
persal when using thisunit, make sure you
leave ample spacebehind the rear panel and
wrap any loosecables so they are notblock-
ing the vents.
5cmcm
Leave ample
space
5 cm
5 cm
! To some typesof vehicles, this unit cannotbe
properly installed. Insuch case, use the op-
tional installation kit(ADT-VA133).
Installation using the screw
holes on the side of the unit
% Fasteningthe unit to the factoryradio-
mounting bracket.
Position the unit so thatits screw holes are
aligned with thescrew holes of the bracket, and
tighten the screwsat 3 locations on eachside.
1
2
3
4
1 If the pawlgets in theway,bend it down.
2 Factory radiomounting bracket
3 Use either truss(5mm ×8mm) or flushsur-
face (5mm× 9mm)screws, dependingon
the bracketscrew holes.
4 Dashboard or console
English
Connection
49
Section
Installation
En
25
26
<CRD4703-B/N>49