Filter
Top Products
Adjusting initial settings
1
Initial settings lets you perform initial setup of
different settings for this unit.
1 Functiondisplay
Shows the function names.
1 Touch the source icon and then touch
OFF to turn this unit off.
# When the source icon is not displayed,you
can display it by touching the screen.
2 Press A.MENU button and touch INIT to
display the initial function names.
The function names are displayed and oper-
able ones are highlighted.
# To go to the nextgroup of function names,
touch NEXT.
# To return to the previousgroup of function
names, touch PREV.
# When the multi-channel processor (e.g.,DEQ-
P6600) is connected to this unit,you can operate
D. ATT and RESET instead of REARSP.
# To return to the previousdisplay, touch BACK.
# To return to the displayof each source, touch
ESC.
Setting the FM tuning step
Normally the FM tuning step employed by
seek tuning is 50 kHz. When AF or TA is on,
the tuning step automatically changes to 100
kHz. It may be preferable to set the tuning step
to 50 kHz when AF is on.
% Touch FMSTEP on the initial menu to se-
lect the FM tuning step.
Touching FMSTEP will switch the FM tuning
step between 50 kHz and 100 kHz while AF or
TA is on. The selected FM tuning step will ap-
pear in the display.
Note
The tuning step remains at 50 kHzduring manual
tuning.
Switching Auto PI Seek
The unit can automatically search for a differ-
ent station with the same programming, even
during preset recall.
% Touch AUTOPI on the initial menu to
turn Auto PI Seek on.
# To turn Auto PI Seekoff, touch AUTOPI
again.
Switching the warning tone
If the front panel is not detached from the
head unit within five seconds of turning off the
ignition, a warning tone will sound. You can
turn off the warning tone.
% Touch D. WARN on the initial menu to
turn warning tone on.
# To turn warning tone off, touch D. WARN
again.
Initial Settings
En
90
Section
19