Filter
Top Products
74
Configuretheeventactionatavideolossoccurrence[Videoloss]
Select the [Video loss] tab on the "Event" page. (+ Page 60)
The settings relating to event actions to be taken at a video loss (+ Operating Instructions (PDF)) occurrence can be configured
on this tab.
[Operationmode]
Select the settings for the operation mode.
Refer to the operating instructions (PDF) for further informa-
tion about the operation mode.
ADM(ActivityDetectionMode): Performs recording,
writes the event log, and moves the cameras to pre-
set positions at an event occurrence. Other event
actions will not be performed.
ALM(AlarmMode): Performs every event action
according to the settings.
OFF: Performs only writing an event log. Other event
actions will not be performed.
Configure the following settings for each camera channel (1
to 16).
[Rec.cam.]
Select a camera channel (1 to 16) used for recording. When
"Off" is selected, recording will not be performed.
[Preset]
Select a preset position (1 to 256) to which the camera will
move at a video loss occurrence.
When the preset positions of two or more cameras have
been selected on the advanced setup page, "∗∗∗" is dis-
played and it is impossible to select the values.