Filter
Top Products
104
Configure the Panasonic alarm protocol settings
[Panasonicalarmprotocol]
Select the [Panasonic alarm protocol] tab on the "Network" page. (+ Page 60)
The settings to notify the PC of the event and error information when an event or an error occurs can be configured on this tab.
To display the event and error information, it is necessary that the dedicated software is installed on the PC.
Refer to the "readme.txt" file on the CD-ROM for details about the software.
[Portnumber(toPC)]
Enter the addresses of the recipient PCs.
Default: 01818
[Retry]
Set the number of retry attempts for the transmission to the
PC.
0 to 8 (times) (In steps of times)
Default: 2
■ Destination address
[Address1toAddress8]
Enter the addresses of the recipient PCs. Enter the IP
address or host name for "Address 1" - "Address 8".
The host name is available only when selecting "Manual" or
"Auto" for the "Network" page - the [DNS] tab.
Up to 8 destinations can be registered.
Enter up to 255 alphanumeric characters including hyphens
(-) and periods (.).