Panasonic WJ-HD716K CD Player User Manual


  Open as PDF
of 156
 
88
ConfigurethedisplaysettingsforMonitor2[Monitor2]
Select the [Monitor 2] tab on the "Display" page. (+ Page 60)
Set the position to display the status bar and select "On" or "Off" to determine whether or not to display the camera title.
The settings relating to the sequence display on Monitor 2 can also be configured on this tab.
[Statusdisplay]
Select the position to display the status bar.
Upper: Displays the status bar on the top of the screen.
Low: Displays the status bar on the bottom of the
screen.
Default: Low:
[Cameratitledisplay]
Select "On" or "Off" to determine whether to enable or dis-
able the camera title display.
[Loginscreen]
Select a camera image to be displayed during the login pro-
cedure.
Available setting values are the same as Monitor 1. Refer to
page 86.
[Livesequence]
Configure the sequential display settings of camera images.
The setup procedure is the same as Monitor 1. Refer to
page 86.
[Sequencetiming]
Determine how to switch camera images.
Int: Switches images according to the settings of the
"Dwell time" of "Live sequence".
Ext: Switches images by signals from an external
device.
Note:
• "Ext"isselectedwhenanexternaldeviceisconnected
to output the sequence signals
• PinNo.21(SequenceSwitching)oftheALARM/
CONTROL connector on the rear panel of the recorder
works as an input terminal when "Int" is set for
"Sequence timing", and works as an output terminal
when "Ext" is set.
Configuring the sequence display settings
Configure the sequential display settings of camera images.
When selecting the [Setup] button of "Live Sequence" on the [Monitor 2] tab, the setup page for live sequence will be displayed.
The setup procedure is the same as Monitor 1. Refer to page 87.
 previous next