Panasonic WJ-HD716K CD Player User Manual


  Open as PDF
of 156
 
99
Configurethesettingsrelatingtonetwork[Network]
The basic network settings required to operate this unit using a PC via a network such as a LAN can be configured on the
"Network" page. The settings relating to the Panasonic alarm protocol and the settings relating to the resolution and rate to
transmit live images can also be configured on this page.
The "Network" page has [Basic], [DNS], [DDNS], [SNMP], [Panasonic alarm protocol] and [Transmission] tabs.
Configurethebasicsettingsrelatingtoanetwork[Basic]
Select the [Basic] tab on the "Network" page. (+ Page 60)
The basic settings relating to a network can be configured on this tab.
[HTTPportnumber]
Specify the HTTP port number to be used to send images
from the unit.
It is unnecessary to change it for normal use.
1 - 65535
Default: 80
Note:
• Dependingonthenetworksettings,networkcommuni-
cation may not be established if the http port number
has been changed. In this case, refer to the administra-
tor of each network. In this case, refer to the administra-
tor of the network.
• ThefollowingnumbersandtheFTPportnumberare
unavailable for the HTTP port number.
20, 21, 23, 25, 42, 53, 67, 68, 69, 79, 105, 110, 123,
161, 162, 546, 547, 995, 10001, 10002, 10003, 10004,
10005, 10006, 10007
[FTPportnumber]
Designate the FTP port number of the recorder.
It is unnecessary to change it for normal use.
1 - 65535
Default: 21
Note:
• ThefollowingnumbersandtheHTTPportnumberare
unavailable for the FTP port number.
20, 23, 25, 42, 53, 67, 68, 69, 79, 80, 105, 110, 123,
161, 162, 546, 547, 995, 10001, 10002, 10003, 10004,
10005, 10006, 10007
■ Network Port
The setting for the network port on the rear panel of the
recorder is configured.
This setting is required to operate the recorder from a PC
connected via a network using the network ports.
[DHCP]
Select "On" or "Off" to determine whether or not to use the
DHCP server.
Select "On" to obtain an IP address, a subnet mask and a
gateway address from the DHCP server.
Set to "Off" when entering the addresses above manually.
The IP address, subnet mask and default gateway obtained
from the DHCP server are displayed on each setting area.
Default: Off
Note:
• WhenthesettingofDHCPischangedfrom"On"to
"Off", the setting of DNS will be automatically changed
to "Off".
 previous next