Panasonic WJ-HD616K CD Player User Manual


  Open as PDF
of 156
 
78
Step 3
Set the end point of the detection area.
Press the [SET] button after moving the cursor to the desired
end point of the detection area using the arrows button (C
D A B). To finish the detection area setting, select the
[Back] button.
Note:
• Detectionareaswillbesetaccordingtothegriddivided
in 16 x 14 segments. It may be possible that the actual
detection areas will not be exactly the same as the des-
ignated start and end points.
• Todeleteasetdetectionarea,selectthe[Deletearea]
tab on the detection area setup page, and click the
[Delete] button of the area (A to D) to be deleted.
• Whenusingamouse,clicktheendpoint.Upto4areas
can be set by repeating Step 1 to 3.
Step 4
Set the detection sensitivity for each detection area.
Move the cursor to the pull-down menu of "Sensitivity" of the
detection area to be set (A to D) using the arrows button (C
D A B). Then, rotate the JogDial (inside) to select the
detection sensitivity from the following.
Off: Ignores motion in the selected area.
Low: Low sensitivity
Mid: Standard sensitivity
High: High sensitivity
Step 5
Select the [Back] button after completing the settings.
→ The detection area setup page will be closed.
 previous next