Panasonic WJ-HD616K CD Player User Manual


  Open as PDF
of 156
 
14
Precautions for Installation
This product is designed for indoor use.
Avoid the following locations for installation.
• Locationsexposedtodirectsunlight
• Placessubjecttohavingstrongvibrationorimpact
• Nearmagneticfieldsourcessuchasatelevisionor
speakers
• Placewherecondensationformseasily,wheretempera-
ture changes greatly, humid places
• Steamyandoilyplacessuchaskitchens
• Placeswhicharenotlevel
• Placessubjecttodust
• Placessubjecttowatersplashorspray
Do not install this product in locations where the prod-
uct or the cables can be destroyed or damaged by
persons with malicious intent.
Place this product horizontally on a level surface.
Do not place this product in an upright position. When
stacking multiple recorders, clear a space of more than 5 cm
{1-31/32"} from both sides, the top, the bottom and the rear
of them.
Heat dissipation
Refer to the following to prevent fire and malfunction of this
product.
• Donotblocktheventilationopeningsinthecovertopre-
vent this product from overheating. Maintain this product
periodically to prevent dust from blocking openings.
• Alifetimeofcoolingfansislimitedbyuse.Itisrecom-
mended to replace them after approx. 30 000 hours of
operation. Contact your dealer for replacement of the
cooling fans.
• Clearaspaceofmorethan5cmfrombothsides,the
top and the rear of this product. Do not block the venti-
lation openings on the front cover since this product is
designed to cool the hard disk drives by inhaling air from
the front.
Avoid placing the unit near noise sources
If the cables are placed near noise sources such as fluores-
cent lamps, noises may be produced. In this case, rewire
avoiding the noise sources, or move this product to a place
far from the source.
Power source
A grounding connection must be made before connecting
the power plug of this product to the main power supply.
When disconnecting the grounding wire, make sure that the
power plug of this product is disconnected from the main
power supply.
How to mount the power cord
Be sure to connect the power cord via any of the following
breaking devices:
• Connectthepowercordviaapowersupplycontrolunit.
• Installtheproductnearapoweroutlet,andconnectthe
power cord via the power plug.
• Connectthepowercordtothebreakerwithcontactgap
of 3.0 mm or more of a distribution board. The breaker
shall be able to shut down all the poles of the main
power supply except the ground protective conductor.
More than
5 cm {1-31/32"}
More than
5 cm {1-31/32"}
More than
5 cm {1-31/32"}
 previous next