Filter
Top Products
75
ConfiguretheeventactionataVMDoccurrence[VMD]
Select the [VMD] tab on the "Event" page. (+ Page 60)
The settings relating to event actions to be taken at a VMD (+ Operating Instructions (PDF)) occurrence can be configured on
this tab.
[OperationMode]
Select the settings for the operation mode. Refer to the
operating instructions (PDF) for further information about the
operation mode.
ADM(ActivityDetectionMode): Performs only
recording and writing an event log at an event occur-
rence. Other event actions will not be performed.
ALM(AlarmMode): Performs every event action
according to the settings.
Off: Performs only writing an event log. Other event
actions will not be performed.
Configure the following settings for each camera channel (1
to 16).
[Rec.cam.]
Select a camera channel (1 to 16) used for recording. When
"Off" is selected, recording will not be performed.
[Preset]
Select a preset position (1 to 256) to which the camera will
move at a VMD detection.
When the preset positions of two or more cameras have
been selected on the advanced setup page, "∗∗∗" is dis-
played and it is impossible to select the values.
[Outputterminal]
Select a terminal (TRM1 to TRM16) to output the alarm sig-
nal.