Filter
Top Products
116
Setting the scene change
Select "On" or "Off " to determine whether to provide an alarm signal when a change in the state of scene occurs by covering the
camera with a cloth, a cap, or others, or by changing the camera direction largely.
Setting the detection mode
Set the detection conditions for "Motion det." and "Object det.". In addition, determine whether or not to display the frames of
detection areas on the screen.
Step 1
Display the setup page for camera's i-VMD function, and
select the desired camera. (+ Page 114)
Step 2
Select the [Mode] tab.
→ The [Mode] tab will be displayed.
[Motiondet.(W&B)]
When "Motion det." is set, select the detection condition
from the following.
Motion: An alarm occurs when a moving object enters
the detection areas.
Loitering: An alarm occurs when an object enters the
detection area and stays for the specified time.
Select the staying time from the following. (An alarm
occurs when the object has been staying for more
than the selected staying time.)
5s/10s/20s/30s/40s/50s/1min
Direction: An alarm occurs when an object enters the
detection area and moves to the specified direction.
Select the direction from the following. Select the
user level from the following.
Off/Right/R-Lower/Lower/L-Lower/Left/
L-Upper/Upper/R-Upper
[Objectdet.(G&R)]
When "Object det." is set, check "Removal and left behind",
and select the detection time from the following.
10s/20s/30s/40s
[Indicator]
Determine whether or not to display the frames for detection
areas.
Off: Does not display frames.
On(All): Displays frames for "Motion det.", "Object det."
and "Scene change".
On(Obj):Displays frames for "Object det." only.
Note:
• When"On"isselected,theframesarerecordedtogether
with the images. It is impossible to delete the frames
from the recorded images.