Filter
Top Products
RQT8926
101
Page
(Continued on the next page)
During play, a “humming”
sound can be heard.
≥Are there power cords or fluorescent lights near any connected cords? Keep this
unit as far away as possible from other electrical devices.
—
I can’t connect to the
network.
≥Has the LAN cable come unplugged? Check that the LAN cable is properly
connected.
≥Have you plugged in a modular cable for use with a telephone into the LAN
terminal on this unit? Connect with a straight LAN cable.
≥Is the power for the modem or broadband router turned on? Turn the power on for
each device.
≥Have you set the unit to use only the internal CD database? Set “CD database
Setting” to “Yes” in “Network” menu.
≥Is there a mistake in the network settings? Follow any instructions you may have
received from your ISP (Internet Service Provider) and make changes to the
settings accordingly.
≥Are the broadband router settings correct? Read the operating instructions for the
broadband router.
≥Is the broadband router and/or modem correctly connected? Check the operating
instructions for each device and connect accordingly.
20
20
—
94
—
—
—
While using my PC, I cannot
connect to the network.
≥Does your Internet Service Provider (ISP) or service contract prevent multiple
terminals connecting at the same time? Check the content and regulations of your
contract.
—
You have forgotten your
ratings password.
Reset all the settings in “Setup
for Video” to Factory Preset.
≥Switch the selector to “DVD/CD”, and when the unit is stopped, simultaneously
press [∫] on the main unit and [S10] on the remote control until “Initialized” is
displayed. All settings in “Setup for Video” will return to the default values.
—
The SUB MENU button
doesn’t work.
≥Is the unit performing the recording? Perform operations after recording finishes. —
General Issues EZ Sync
EZ Sync “HDAVI Control”
does not work.
≥Check the connection of the HDMI cable.
≥Is “EZ Sync” set to “On” in the “HDMI” menu?
≥Check the EZ Sync settings on the connected device.
≥If the HDMI device connection was changed, there has been a power failure, or the
plug was removed and then reinserted to the power outlet, EZ Sync may stop
working. In any of these cases, perform the steps listed below.
1 Turn on the power to all devices connected with an HDMI cable, and then turn the
TV (VIERA) off and on again.
2 Turn the EZ Sync settings on the TV(VIERA) to “Off” and then “On” again. (For
more information, refer to the VIERA operating instructions.)
3 Switch the VIERA input to the HDMI connection with this unit, and after this unit’s
screen is displayed, check the EZ Sync operations.
17
93
—
—
Playback Issues Operation
Recorded tracks are not
displayed, and cannot be
found.
≥If it is difficult to find the playlist that a track was added to, search by the name of
the track. All tracks in the Music Collection will be displayed by track name.
47
Tracks have not been added
to “Music Shuffle”.
≥Are you playing the track immediately after recording it? Adding the track to Music
Shuffle takes place when the unit is in standby mode.
≥Does this abnormality only occur with specific tracks? Depending on the track, it
may not be added to any genre.
—
49
The display does not change
even after inserting a disc.
Play does not begin even
after pressing [1](PLAY).
≥Does the inserted disc conform to disc standards and specifications? Replace it
with a disc that conforms to disc standards.
≥Condensation has formed: Wait 1 to 2 hours for it to evaporate.
24
—
Reference
Reference
PTX79P.book Page 101 Monday, April 9, 2007 9:24 AM