Panasonic PT-DZ16KE Home Theater System User Manual


 
Chapter 1Preparation — Start-up display
ENGLISH - 25
Initial setting (installation setting 1)
Set [PROJECTION METHOD] depending on the installation mode. Refer to “Installation mode” (x page 35) for details.
Set [HIGH ALTITUDE MODE] to [ON] when using the projector at high altitudes between 1 400 m (4 593') and 2 700 m (8 858') above sea
level.
After completed the initial setting, you can change the settings of each item from the [PROJECTOR SETUP] menu.
1) Press as to select an item.
2) Press qw to switch the setting.
When PROJECTION METHOD is changed, confirm that
COOLING CONDITION is set correctly.
Switch to HIGH ALTITUDE MODE "ON" if over 1400m
(4593Ft).
INITIAL SETTING
SET
CHANGEMENU SELECT
PROJECTION METHOD
HIGH ALTITUDE MODE
FRONT/FLOOR
OFF
ENTER
3) Press the <ENTER> button to proceed to the initial setting.
Initial setting (installation setting 2)
Set [COOLING CONDITION] depending on the installation mode. Refer to “Installation mode” (x page 35) for details.
After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu [COOLING CONDITION].
1) Press qw to switch the setting.
It may shorten the life of the lamp and projector if used
in incorrect setting.
INITIAL SETTING
SET
CHANGE
COOLING CONDITION
AUTO
ENTER
2) Press the <ENTER> button to proceed to the initial setting.