Filter
Top Products
Connecting
46 - ENGLISH
Getting Started
■
For <SDI IN 1>/<SDI IN 2> terminals (for PT-DZ21KU and PT-DS20KU
only)
+'6',VLJQDORU
6'6',VLJQDO
'LJLWDO9&5IRUFRPPHUFLDOXVH
Note
z
Use [SYSTEM SELECTOR] (
page 70) to switch the input format.
z
Some external devices to be connected require [SDI IN] (
page 93) to be set.
z
Use a 5CFB or higher (such as 5CFB, or 7CFB) or a Belden 1694A or higher connection cable to properly
transmit images. Use a connection cable of 100 m (328'1") length or less.
z
To enter dual link signals, the [SDI LINK] in [SDI IN] must be set.
z
Use the same length and same type of cables to connect <SDI IN 1>/<SDI IN 2> terminals when entering
dual link signals. If there is a difference of 4 m (13'1") or greater in cable length, images may not be projected
properly.
z
To input dual link signals, connect directly without going through a distributor or other such device to the
external device which outputs signals. A phase difference may occur between the LINK-A signal and the
LINK-B signal and images may not be projected properly.
z
When an unsteady signal is connected, an error in signal detection may occur. In such a case, use the [SYSTEM
SELECTOR] (
page 70) to switch to a system that matches the signal format.