Filter
Top Products
82
Advanced Setup—Continued
Dimension
With this setting, you can move the sound field forward
or backward when using the Dolby Pro Logic II Music
or Dolby Pro Logic IIx Music listening mode. It can be
adjusted from –3 to +3 (default is 0). Lower settings
move the sound field forward. Higher settings move it
backward.
If the stereo image feels too wide, or there is too much
surround sound, move the sound field forward to
improve the balance. Conversely, if the stereo image
feels like it is in mono, or there is not enough surround
sound, move it backward.
Center Width
With this function, you can adjust the width of the sound
from the center speaker when using the Dolby Pro Logic
II Music or Dolby Pro Logic IIx Music listening mode.
Normally, if you are using a center speaker, the center
channel sound is output by only the center speaker. (If
you are not using a center speaker, the center channel
sound will be distributed to the front left and right speak-
ers to create a phantom center.) This setting controls the
front left, right, and center mix, allowing you to adjust
the weight of the center channel sound. It can be adjusted
from 0 to 7 (default is 3).
■ Neo:6 Music
Center Image
The DTS Neo:6 Music listening mode creates 6-channel
surround sound from 2-channel (stereo) sources. With
this setting, you can specify by how much the front left
and right channel output is attenuated in order to create
the center channel. It can be adjusted from 0 to 5 (default
is 2). This setting is unavailable if no surround speakers
are connected.
When set to 0, the front left and right channel output is
attenuated by half (–6 dB), giving the impression that the
sound is located centrally. This setting works well when
the listening position is considerably off center. When
set to 5, the front left and right channels are not attenu-
ated, maintaining the original stereo balance.
Dolby EX Input Signal Setting
■ Dolby EX
This setting determines how Dolby EX encoded signals
are handled. This setting is unavailable if no surround
back speakers are connected. This setting is effective
with Dolby Digital, Dolby Digital Plus and Dolby
TrueHD only.
T-D (Theater-Dimensional) Listening
Setting
■ Listening Angle
With this setting, you can specify the angle of the front
left and right speakers relative to the listening position.
Processing for the Theater-Dimensional listening mode
is based on this setting. Ideally, the front left and right
speakers should be equidistant from the listening position
and at an angle close to one of the two available settings.
DSD Setting
■ DAC Direct
This setting determines whether or not DSD (SACD)
audio signals are passed through the DSP for A/V Sync,
delay, etc., processing when the Pure Audio or Direct lis-
tening mode is selected.
LFE Level Settings
With these settings, you can set the level of the LFE
(Low Frequency Effects) channel individually for Dolby
Digital, DTS, multichannel PCM, Dolby TrueHD, DTS-
HD Master Audio, and DSD sources. The level can be
set to –
∞, –10 dB, or 0 dB (default).
If you find that low-frequency effects are too loud when
using one of these sources, change the setting to –10 dB
or –
∞ dB.
■ Dolby Digital
Sets the level of the LFE channel for Dolby Digital and
Dolby Digital Plus sources.
■ DTS
Sets the level of the LFE channel for DTS and DTS-HD
High Resolution sources.
■ Multich PCM
Sets the level of the LFE channel for multichannel PCM
sources. (Multichannel PCM is input via HDMI.)
■ Dolby TrueHD
Sets the level of the LFE channel for Dolby TrueHD sources.
■ DTS-HD Master Audio
Sets the level of the LFE channel for DTS-HD Master
Audio sources.
■ DSD
Sets the level of the LFE channel for DSD (SACD) sources.
Auto: If the source signal contains a Dolby EX
flag, the Dolby EX or THX Surround EX
listening mode is used (default).
Manual:
You can select any available listening mode.
Narrow: Select if the angle is less than 30 degrees.
Wide: Select if the angle is greater than 30
degrees (default).
No: DSD signals are processed by the DSP
(default).
Ye s: DSD signals are not processed by the DSP.
30˚
Front right speakerFront left speaker