Filter
Top Products
40
Turning On the AV Receiver/AV Amplifier
STANDBY/ON
ON/STANDBY
RECEIVER
STANDBY indicator
Turning On and Standby
Press the [ON/STANDBY] button.
Alternatively, press the remote controller’s [RECEIVER] button, followed
by the [ON/STANDBY] button.
The AV receiver/AV amplifier comes on, the display lights up, and the STANDBY
indicator goes off.
To turn the AV receiver/AV amplifier off, press the [ON/STANDBY] button, or press
the remote controller’s [ON/STANDBY] button. The AV receiver/AV amplifier will
enter Standby mode. To prevent any loud surprises when you turn on the AV
receiver/AV amplifier, always turn down the volume before you turn it off.
or
R
emo
t
e
controller
AV
rece
i
ver
/
AV amplifier
Smooth Operation in a Few Easy Steps
To ensure smooth operation, here’s a few easy steps to help you configure the AV receiver/AV amplifier before you
use it for the very first time. These settings only need to be made once.
■ Do the automatic speaker setup—this is essential!
See “Automatic Speaker Setup (Audyssey MultEQ
®
)” on page 49.
■ Have you connected a component to an HDMI input,
component video input, or digital audio input?
If you have, see “HDMI Input Setup” on page 42, “Component Video
Setup” on page 43, or “Digital Input Setup” on page 44 respectively.
■ Have you connected an Onkyo MD recorder, CD recorder,
or RI Dock?
If you have, see “Changing the Input Display” on page 48.
HDMI
OUT IN
TAPE
CD recorder, MD recorder,
RI Dock