Filter
Top Products
57
Listening to the Radio (TX-SR706 only)
With the built-in tuner you can enjoy AM and FM radio
stations. You can store your favorite stations as presets
for quick selection.
Listening to the Radio
Tuning into Radio Stations
■ Auto Tuning Mode
When tuned into a station, the TUNED indicator
appears. When tuned into a stereo FM station, the FM
STEREO indicator appears on the display, as shown.
■ Manual Tuning Mode
The North American models change FM frequency in
0.2 MHz steps, 10 kHz steps for AM. For other models
it’s 0.05 MHz steps for FM and 9 kHz steps for AM.
In Manual Tuning mode, FM stations will be in mono.
Tuning into weak FM stereo stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
Manual Tuning mode and listen to the station in mono.
■ Tuning into Stations by Frequency
You can tune into AM and FM stations directly by enter-
ing the appropriate frequency.
Using the Tuner
Use the [TUNER] input selector
button to select either AM or FM.
In this example, FM has been selected.
Each time you press the [TUNER] but-
ton, the input source changes between
AM and FM.
(Actual display depends on country)
1
Press the [TUNING MODE] but-
ton so that the AUTO indicator
appears on the display.
2
Press the TUNING Up or Down
[ ]/[ ] buttons.
Searching stops when a station is
found.
TUNER
TUNING MODE TUNING /
Band Frequency
1
Press the [TUNING MODE] but-
ton so that the AUTO indicator
disappears from the display.
2
Press and hold the TUNING Up or
Down [ ]/[ ] buttons.
The frequency stops changing when
you release the button.
Press the buttons repeatedly to change
the frequency one step at a time.
1
Remote
controller
Press the [TUNER] button repeat-
edly to select AM or FM, followed
by the [D.TUN] button.
(Actual display depends on country.)
2
Within 8 seconds, use the num-
ber buttons to enter the fre-
quency of the radio station.
For example, to tune to 87.5 (FM),
press 8, 7, 5.
TUNED
FM
S
TERE
O
AUTO