Filter
Top Products
79
Advanced Setup—Continued
Notes:
• When the listening mode is set to Direct or Pure
Audio, no effect will be produced.
• The Equalizer settings have no effect on 176.4/ 192
kHz input signals.
• This procedure can also be performed on the AV
receiver/AV amplifier by using its [SETUP] button,
arrow buttons, and [ENTER] button.
THX Audio Setup
With the “Surr Back Sp Spacing” setting, you can spec-
ify the distance between your surround back speakers.
If you’re using a THX-certified subwoofer, set the “THX
Ultra2/Select2 Subwoofer” setting to “Yes”. You can
then apply THX’s Boundary Gain Compensation (BGC)
to compensate the perceived exaggeration of low fre-
quencies for listeners sitting very close to a room bound-
ary (i.e., wall).
You can also set the THX Loudness Plus. When the
“Loudness Plus” is set to “On”, it is possible to enjoy
even subtle nuances of audio expression at low volume.
This result is only available when the THX listening
mode is selected.
6
Use the Up and Down [ ]/[ ] but-
tons to select a frequency, and
then use the Left and Right [ ]/
[ ] buttons to adjust the level at
that frequency.
You can select: “63Hz”, “160Hz”,
“400Hz”, “1000Hz”, “2500Hz”,
“6300Hz”, or “16000Hz”. And for the
subwoofer, “25Hz”, “40Hz”, “63Hz”,
“100Hz”, or “160Hz”.
The volume at each frequency can be
adjusted from –6 to +6 dB in 1 dB
steps.
Tip:
Low frequencies (e.g., 160Hz) affect
bass sounds; high frequencies (e.g.,
6300Hz) affect treble sounds.
7
Use the Up and Down [ ]/[ ] but-
tons to select “Channel”, and
then use the Left and Right [ ]/
[ ] buttons to select another
speaker.
Repeat step 6 and 7 for each speaker.
8
Press the [SETUP] button.
The setup menu closes.
1
Remote
controller
Press the [RECEIVER] button,
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [ ]/[ ] but-
tons to select “2. Speaker
Setup”, and then press [ENTER].
The “Speaker Setup” menu appears.
3
Use the Up and Down [ ]/[ ] but-
tons to select “6. THX Audio
Setup”, and then press [ENTER].
The “THX Audio Setup” screen
appears.
These settings are not set automatically by the Auto-
matic Speaker Setup function (see page 49).
2. Speaker Setup
1. Speaker Settings
2. Speaker Configuration
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
6. THX Audio Setup
2–6. THX Audio Setup
Surr Back Sp Spacing
THX Ultra2/Select2 Subwoofer
BGC
Loudness Plus
> 4ft
No
- - -
On