Filter
Top Products
112
Controlling Other Components—Continued
You can program the remote controller’s MACRO but-
tons to perform a sequence of remote control actions.
Example:
To play a CD you typically need to perform the follow-
ing actions:
1. Press the [RECEIVER] button to select the Receiver
remote controller mode.
2. Press the [ON/STANDBY] button to turn on the AV
receiver/AV amplifier.
3. Press the [CD] button to select the CD input source.
4. Press the Play [ ] button to start playback on the
CD player.
You can program a MACRO button so that all four
actions are performed with just one button press.
Making Macros
Each MACRO button can store one macro, and each
macro can contain up to 32 commands.
Note:
If any of the buttons you used to make a macro are taught
new commands, the macro will no longer work properly
and will have to be made again.
Running Macros
Deleting Macros
Using Macros
1
(3 seconds)
While holding down the
[RECEIVER] button, press and
hold down the MACRO button [1]
or [2] until the [RECEIVER] but-
ton lights up (about 3 seconds).
2
Press the buttons whose actions
you want to program into the
macro in the order you want them
performed.
For the CD example above, you’d press
the following buttons: [ON/
STANDBY], [CD], Play [ ].
MACRO
1, 2
REMOTE
MODE
RECEIVER
3
When you’ve finished, press the
MACRO button again.
The REMOTE MODE button flashes
twice.
If you enter 32 commands, the process
will finish automatically.
Press the MACRO [1] or [2] but-
ton.
The commands in the macro are trans-
mitted in the order in which they were
programmed. Keep the remote control-
ler pointed at the AV receiver/AV
amplifier until all of the commands
have been transmitted.
Macros can be run at any time, regard-
less of the current remote controller
mode.
1
(3 seconds)
While holding down the
[RECEIVER] button, press and
hold down the MACRO button
whose macro you want to delete
until the [RECEIVER] button
lights up (about 3 seconds).
2
Press the MACRO button again.
The [RECEIVER] button flashes twice.