Filter
Top Products
14
Remote Controller
Notes:
• If the remote controller doesn’t work reliably, try
replacing the batteries.
• Don’t mix new and old batteries or different types of
batteries.
• If you intend not to use the remote controller for a long
time, remove the batteries to prevent damage from
leakage or corrosion.
• Expired batteries should be removed as soon as possi-
ble to prevent damage from leakage or corrosion.
To use the remote controller, point it at the AV
receiver/AV amplifier’s remote control sensor, as shown
below.
Notes:
• The remote controller may not work reliably if the AV
receiver/AV amplifier is subjected to bright light, such
as direct sunlight or inverter-type fluorescent lights.
Keep this in mind when installing.
• If another remote controller of the same type is used in
the same room, or the AV receiver/AV amplifier is
installed close to equipment that uses infrared rays,
the remote controller may not work reliably.
• Don’t put anything, such as a book, on the remote con-
troller, because the buttons may be pressed inadvert-
ently, thereby draining the batteries.
• The remote controller may not work reliably if the AV
receiver/AV amplifier is installed in a rack behind col-
ored glass doors. Keep this in mind when installing.
• The remote controller will not work if there’s an
obstacle between it and the AV receiver/AV ampli-
fier’s remote control sensor.
• When the remote control codes have been registered
and you want to operate another component
(page 102), or when you want to operate an Onkyo
component without connection, point the remote
controller at the other component to use it.
• When you want to operate an Onkyo component with
connection or an -compatible compo-
nent connected via HDMI (page 104), point the
remote controller at the AV receiver/AV amplifier’s
remote control sensor.
Installing the Batteries
1
To open the battery compartment, press
the small lever and remove the cover.
2
Insert the two supplied batteries (AA/R6)
in accordance with the polarity diagram
inside the battery compartment.
3
Replace the cover and push it shut.
Aiming the Remote Controller
Remote control sensor
AV receiver/AV amplifier
Approx. 16 ft. (5 m)
STANDBY indicator