Filter
Top Products
111
Controlling Other Components—Continued
The AV receiver/AV amplifier’s remote controller can
learn the commands of other remote controllers. By
transmitting, for example, the Play command from your
CD player’s remote controller, the remote controller can
learn it, and then transmit the exact same command
when its Play [ ] button is pressed in the CD remote
mode.
This is useful when you’ve entered the appropriate
remote control code (page 102) but some buttons don’t
work as expected.
Notes:
• The following buttons cannot learn new commands:
REMOTE MODE, MACRO [1], [2].
• The remote controller can learn approximately 70 to
90 commands, although this will be less if commands
that use a lot of memory are learned.
• Remote controller buttons such as Play, Stop, Pause,
and so on are preprogrammed with commands for
controlling Onkyo CD players, cassette decks, and
DVD players. However, they can learn new com-
mands, and you can restore the preprogrammed com-
mands at any time by resetting the remote controller
(see page 103).
• To overwrite a previously learned command, repeat
this procedure.
• Depending on the remote controller that you are using,
there may be some buttons that won’t work as
expected, or even some remotes that cannot be learned
at all.
• Only commands from infrared remote controllers can
be learned.
• When the remote controller’s batteries expire, all
learned commands will be lost and will have to be
learned all over again, so don’t discard your other
remote controllers.
■ Deleting Learning Commands
1. While holding down the REMOTE MODE button
for the mode in which you want to delete the com-
mand, press and hold down the TV [ ] button
until the REMOTE MODE button lights up (about 3
seconds).
2. Press the REMOTE MODE button or the button
from which you want to delete the commands.
The REMOTE MODE button flashes twice.
When you press the REMOTE MODE button, all
commands learned in that remote mode will be
deleted.
Learning Commands
1
(3 seconds)
While holding down the REMOTE
MODE button for the mode in
which you want to use the com-
mand, press and hold down the
[ON/STANDBY] button until the
REMOTE MODE button lights up
(about 3 seconds).
2
On the supplied remote control-
ler, press the button you want to
learn the new command.
3
Point the remote controllers at
each other, about 2 to 6 inches
(5–15 cm) apart, and then press
and hold the button whose com-
mand you want to learn until the
REMOTE MODE button flashes.
1
1, 4
If the command is learned successfully,
the REMOTE MODE button flashes
twice.
4
To learn more commands, repeat
steps 2 and 3.
Press any REMOTE MODE button
when you’ve finished. The REMOTE
MODE button flashes twice.
POWER
SLEEP
DIMM
ER
SUR
MO
DE
V
IDEO-1
VIDEO-2
T
APE
DVD
C D
C D
DVD
TU
N
ER
T
UNER
PHONO
INPUT SELECTOR
DISC
VOLUME
CH SEL
PRESE
T
UT
ING
TES
T
TONE
MULTI-CH
INPUT
GROUP
About 2 to 6
inches (5–15 cm)
Supplied
remote controller
(
RC-717M
)