Filter
Top Products
73
Advanced Setup—Continued
Some of the settings in this section are set automatically
by the Automatic Speaker Setup function (see page 49).
Here you can check the settings made by the Automatic
Speaker Setup function, or set them manually, which is
useful if you change one of the connected speakers after
using the Automatic Speaker Setup function.
Note:
The Speaker Setup cannot be carried out while head-
phones are connected to the AV receiver/AV amplifier.
Speaker Settings
See “Speaker Settings” on page 45.
Speaker Configuration
With these settings, you can specify which speakers are
connected and a crossover frequency for each speaker.
The following crossover frequencies can be specified:
“Full Band”, “40Hz”, “50Hz”, “60Hz”, “70Hz”, “80Hz
(THX)”, “90Hz”, “100Hz”, “120Hz”, “150Hz”, or
“200Hz”.
Specify “Full Band” for speakers that can output low-
frequency bass sounds adequately, for example, speakers
with a good sized woofer. For smaller speakers, specify
a crossover frequency. Sounds below the crossover fre-
quency will be output by the subwoofer instead of the
speaker. Refer to your speaker’s manuals to determine
the optimum crossover frequencies.
Please note that THX recommends any THX main
speakers be set to “80Hz(THX)”. If you set up your
speakers using the Automatic Speaker Setup function,
please make sure manually that any THX speakers are
set to 80 Hz (THX) crossover.
Speaker Setup
These settings are set automatically by the Automatic
Speaker Setup function (see page 49).
1, 12
2-11
1
2, 3
1
Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [ ]/[ ] but-
tons to select “2. Speaker
Setup”, and then press [ENTER].
The “Speaker Setup” menu appears.
3
Use the Up and Down [ ]/[ ] but-
tons to select “2. Speaker Con-
figuration”, and then press
[ENTER].
The “Speaker Configuration” menu
appears.
4
Use the Up and Down [ ]/[ ] but-
tons to select “Subwoofer”, and
then use the Left and Right [ ]/
[ ] buttons to select:
Ye s: Select if a subwoofer is con-
nected.
No: Select if no subwoofer is con-
nected.
2. Speaker Setup
1. Speaker Settings
2. Speaker Configuration
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
6. THX Audio Setup
2–2. Speaker Configuration
Subwoofer
Front
Center
Surround
Surr Back
Surr Back Ch
LPF of LFE
Double Bass
Yes
80Hz (THX)
80Hz (THX)
80Hz (THX)
80Hz (THX)
2ch
80Hz (THX)
Off (THX)