Filter
Top Products
Operating Other Components with the Remote Controller
En-53
Operating Other Components with
the Remote Controller
Functions of REMOTE MODE Buttons
You can control any other device than this unit by
programming a specified remote control code to a
REMOTE MODE button of the remote controller. Register
a remote control code to a desired REMOTE MODE button
and press it to enter the remote mode that allows you to
operate the corresponding device.
¼½ The RECEIVER and ZONE2 buttons cannot be programmed.
Programming Remote Control Codes
¼ Searching in the Setup Menu
You can search a remote control code and register it to a
desired REMOTE MODE button in the unit's Setup menu.
1. After pressing RECEIVER on the remote controller,
press SETUP.
2. With the cursors, select "7. Remote Controller" -
"Remote Mode" and press ENTER.
3. With the cursors, select the REMOTE MODE button
for which you want to register a remote control code
and press ENTER to display the subcategory selection
screen.
4. With the cursors, select the target subcategory, and then
press ENTER to display the brand name input screen.
5. Select a character with the cursors and press ENTER.
Repeat it to enter the first three characters of the brand
name.
6. Select "Search" with the cursors and press ENTER.
● After a search is done, the list of possible brand
names is displayed. If the brand name list is not
displayed, select "Not Listed" with the cursors and
press ENTER to return to the brand name input
screen in step 5.
7. With the cursors, select the target brand name, and then
press ENTER.
● When the brand name is specified, the remote
control code of the brand and how to register it will be
displayed on the TV screen.
8. Follow the guidance displayed on the TV screen.
9. If the component can successfully be operated with its
registered remote control code, select "OK" with the
cursors and press ENTER.
● Only TV remote control codes can be entered for TV.
● Program a remote control code in accordance
with the input since each button also works as the
input selector. (For example, when the CD player
is connected to the CD jack, program the remote
control code for the CD player to CD)
● If the component cannot be operated, select "Try
Next Code" with the cursors and press ENTER to
display another code.