Filter
Top Products
Advanced Settings (Setup Menu)
En-52
7� Remote Controller
Setting Item Default Value Setting Details
Remote ID 1 Select an ID for the unit's remote controller
from "1", "2", and "3" to prevent interference
between the unit and other Onkyo components
that are installed in the same room. After
changing the ID on the main unit, change the
ID on the remote controller accordingly with the
following procedure.
1. While holding down RECEIVER, press and
hold SETUP for about 3 seconds until the
remote indicator lights.
2. With the number buttons, press one of 1, 2,
and 3. The remote indicator flashes twice.
Remote Mode – Input and register the remote controller code of
other devices.
● For registration of the remote control code,
refer to "Operating Other Components with
the Remote Controller".
8� Miscellaneous
Firmware Update
Setting Item Default Value Setting Details
Update Notice Enable Availability of a firmware update will be notified
via network.
"Enable": Notify updates
"Disable": Do not notify updates
Version – The current firmware version will be displayed.
Update via NET – Press ENTER to select when you want to
update the firmware via network.
● You will not be able to select this setting if
you do not have Internet access or there is
nothing to update.
Update via USB – Press ENTER to select when you want to
update the firmware via USB.
● You will not be able to select this setting if
a USB storage device is not connected or
there is nothing to update in the USB storage
device.
● Wait for a while if "Firmware Update" cannot be selected. It will appear when the network function is
started up.
Initial Setup
You can make the initial setup from the setup menu.
● Wait for a while if "Initial Setup" cannot be selected. It will appear when the network
function is started up.
Lock
Setting Item Default Value Setting Details
Setup Parameter Unlocked
Lock the Setup menu to protect the settings.
"Locked": The menu is locked.
"Unlocked": The menu is unlocked.