Filter
Top Products
Step 1: Connections
En-10
3 Other connections
AM/FM antenna connections
Connect the antennas to listen to AM/FM broadcast. When
listening to the broadcast for the first time, adjust the
antenna position and orientation to get the best reception.
AM loop antenna
(supplied)
Indoor FM antenna
(supplied)
Fix with a tack on
the wall.
(North American and
Taiwanese models)
(European, Australian
and Asian models)
Assemble the AM loop antenna (supplied).
Network connection
You can enjoy Internet radio, DLNA and AirPlay by
connecting the unit to LAN. The unit can be connected to
the router with an Ethernet cable or to the wireless LAN
router with Wi-Fi connection. In case of wired connection,
connect the Ethernet cable to the Ethernet port. See
Network Connection" of "Step 2: Initial Setup" for Wi-Fi
settings.
Internet radio
Router
NAS
Headphones connection
Connect stereo headphones with a standard plug (1/4
inch or ø 6.3 mm) to the PHONES jack on the front panel.
Sound from the speakers will be off while you are using the
headphones.
If you selected any other listening mode than Pure
Audio (European, Australian and Asian models), Stereo,
Mono and Direct, connecting headphones will switch the
listening mode to Stereo.
Power cord
European and Taiwanese models include removable power
cords. Connect the power cord to AC INLET of the unit and
then connect to the outlet. Always disconnect the outlet
side first when disconnecting the power cord. When the
unit is turned on, a large instantaneous current may flow
affecting functionality of the computer and other devices, so
it is recommended to use a separate outlet.