Filter
Top Products
Advanced Settings (Setup Menu)
En-38
Setting Item Default Value Setting Details
Powered Zone 2 No Set the connection of speakers to Zone 2 speaker
terminals.
"Yes": When speakers are connected to ZONE2
speaker terminals
"No": When speakers are not connected to ZONE2
speaker terminals
● This item will be set to "No" when "Bi-Amp" is set
to "Yes".
Speaker
Impedance
6ohms Set the impedance of the connected speakers.
"4ohms": When any of the connected speakers have
"6ohms": When the connected speakers all have
● For impedance, check the indications on the back
of the speakers or their instruction manual.
Crossover
Allows you to change speaker configurations, such as crossover frequency. Settings are
automatically configured if you use the Automatic Speaker Setup. Audio will not be output
while you are making this setting.
● If you are using THX-certified speakers, we recommend the following settings:
– Set a value "80Hz(THX)" in Crossover frequency.
– Set a value "80Hz(THX)" in LPF of LFE.
– Set a value "Off(THX)" in Double Bass.
Setting Item Default Value Setting Details
Front
80 Hz(THX)
Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
● If "Configuration" - "Subwoofer" is set to "No",
"Front" will be fixed to "Full Band" and the low
pitched range of the other channels will be output
from the front speakers. Refer to the instruction
manual of your speakers to make the setting.
Setting Item Default Value Setting Details
Center
80 Hz(THX)
Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
● "Full Band" can be selected only when "Front" is
set to "Full Band".
● If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
Height
80 Hz(THX)
Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
● "Full Band" can be selected only when "Front" is
set to "Full Band".
● If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
Surround
80 Hz(THX) Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
● "Full Band" can be selected only when "Front" is
set to "Full Band".
● If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.