Filter
Top Products
51
First Time Setup—Continued
Notes:
• When the automatic speaker setup is complete, the
“Equalizer Settings” (page 95) will be set to “
Audys-
sey
”.
• You can cancel the automatic speaker setup at any
point in this procedure simply by disconnecting the
setup microphone.
6
After the 3rd to the 5th measure-
ment, the following screen
appears.
Use the Up and Down [ ]/[ ] but-
tons to select an option, and then
press [Enter].
Next:
Select “Next” to begin measuring
the next measurement position.
After the 6th measurement has been
taken, the procedure automatically
proceeds to step 7.
Finish (Calculate):
Select this if you don’t want to
measure any more listening posi-
tions and are ready to calculate the
results, then go to step 7.
7
When the measurements are
complete, the following screen
appears.
8
When the calculations are com-
plete, the following screen
appears.
Auto Speaker Setup
Select [Next] to measure the next position,
or select [Finish] to calculate
the Audyssey MultEQ room EQ solution.
Next
Finish(Calculate)
Auto Speaker Setup
Calculating...
Auto Speaker Setup
Subwoofer : No
Front : Full Band
Center : None
Surround : None
Surr Back : None
Surr Back Ch : - - -
Save
Cancel
Review SP Configuration
Use the Up and Down [ ]/[ ] but-
tons to select an option, and then
press [Enter].
The options are:
Save:
Save the calculated settings and exit
the automatic speaker setup.
Cancel:
Cancel the automatic speaker setup.
Note:
You can view the calculated settings for
the speaker configuration, speaker dis-
tances, and speaker levels by using the
Left and Right [ ]/[ ] buttons.
9
If you selected “Save”, the results are
saved, and the following screen
appears.
10
Disconnect the speaker setup
microphone.
Auto Speaker Setup
Saving...
Please, unplug Setup Mic.
Auto Speaker Setup