Filter
Top Products
108
Advanced Setup—Continued
.
This section explains items on the “Hardware Setup” menu.
Note:
This procedure can also be performed on the AV receiver
by using its [Setup] button, arrow buttons, and [Enter]
button.
Remote Control
■ Remote ID
When several Integra/Onkyo components are used in the
same room, their remote ID codes may overlap. To differ-
entiate the AV receiver from the other components, you
can change its remote ID from 1, the default, to 2 or 3.
Note:
If you do change the AV receiver’s remote ID, be sure to
change the remote controller to the same ID (see below),
otherwise, you won’t be able to control it with the remote
controller.
Changing the Remote Controller’s ID
Zone 2
See “Zone 2” on page 114.
Tuner
■ AM Frequency Step (not North American
models)
See “AM Frequency Step Setup
(not North American models)” on page 47.
■ SAT Radio Mode (on North American model)
If you connect an XM Satellite Radio antenna or SIRIUS
Satellite Radio antenna to the AV receiver (both sold
separately), set this setting to “XM” or “SIRIUS”
respectively. If you connect both types of antenna, select
“XM/SIRIUS”. Otherwise, select “None”. See “Listen-
ing to XM Satellite Radio
®
(North American Model
Only)” on page 59 and see “Listening to SIRIUS Satel-
lite Radio
®
(North American Models Only)” on page 66
for more information.
■ Antenna Aiming (on North American model)
The ID of the Sirius Connect Home Tuner is displayed
here. You must sign up to obtain a SIRIUS ID. See
“Positioning the SiriusConnect Home antenna” on
page 74 for more information.
See “Positioning the XM Mini-Tuner System” on
page 64 for information about the XM Mini-Tuner
Antenna.
Hardware Setup
1
Remote
controller
Press the [Receiver] button fol-
lowed by the [Setup] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [ ]/[ ] but-
tons to select “7. Hardware
Setup”, and then press [Enter].
The “Hardware Setup” menu appears.
3
Use the Up and Down [ ]/[ ] but-
tons to select an item, and then
press [Enter].
The screen for that item appears.
4
Use the Up and Down [ ]/[ ] but-
tons to select an item, and use
the Left and Right [ ]/[ ] but-
tons to change it.
The items are explained below.
5
When you’ve finished, press the
[Setup] button.
The setup menu closes.
7. Hardware Setup
1. Remote Control
2. Zone2
3. Tuner
4. Analog Multich
5. HDMI
6. Network
1
While holding down the
[Receiver] button, press and hold
down the [Setup] button until the
[Receiver] button lights up
(about 3 seconds).
2
Use the number buttons to enter
ID 1, 2, or 3.
The [Receiver] button flashes twice.
Remote
controller
(3 seconds)