Filter
Top Products
123
Controlling Other Components—Continued
Integra/Onkyo components that are connected via
are controlled by pointing the remote controller at the
AV receiver, not the component. This allows you to con-
trol components that are out of view, in a rack, for exam-
ple.
If you want to control an Integra/Onkyo component by
pointing the remote controller directly at it, or you want
to control an Integra/Onkyo component that’s not con-
nected via , use the following remote control codes:
•[DVD] button
30627: Integra/Onkyo DVD player without
(default)
• [CD] button
71817: Integra/Onkyo CD player without
(default)
Note:
If you connect an -capable Onkyo MiniDisc
recorder, CD recorder, or RI Dock to the TAPE IN/OUT
jacks, or connect an RI Dock to the Game/TV jacks, for
to work properly, you must set the Input Display
accordingly (see page 48).
You can reset a Remote Mode button to its default
remote control code.
You can reset the remote controller to its default settings.
Remote Control Codes for Integra/
Onkyo Components Connected via
1
Make sure the Integra/Onkyo component
is connected with an cable and an ana-
log audio cable (RCA).
See page 38 for details.
2
Enter the appropriate remote control code
for the Remote Mode button.
• [DVD] button
31612: Integra/Onkyo DVD player with
•[CD] button
71327: Integra/Onkyo CD player with
• [Tape] button
42157: Onkyo cassette recorder with
(default)
See the previous page for how to enter remote
control codes.
3
Press the Remote Mode button, point the
remote controller at the AV receiver, and
operate the component.
Resetting Remote Mode Buttons
1
(3 seconds)
While holding down the Remote
Mode button that you want to
reset, press and hold down the
[Audio] button until the Remote
Mode button lights up (about 3
seconds).
2
Within 30 seconds, press the
Remote Mode button again.
The Remote Mode button flashes
twice, indicating that the button has
been reset.
Each of the Remote Mode buttons is
preprogrammed with a remote control
code. When a button is reset, its prepro-
grammed code is restored.
Resetting the Remote Controller
1
(3 seconds)
While holding down the
[Receiver] button, press and hold
down the [Audio] button until the
[Receiver] button lights up
(about 3 seconds).
2
Within 30 seconds, press the
[Receiver] button again.
The [Receiver] button flashes twice,
indicating that the remote controller
has been reset.