Filter
Top Products
111
Advanced Setup—Continued
■ Control
This function allows -compatible components
connected via HDMI to be controlled with the AV
receiver.
Notes:
• , which stands for Remote Interactive over
HDMI, is the name of the system control function
found on Integra/Onkyo components. The AV receiver
can be used with CEC (Consumer Electronics Con-
trol), which allows system control over HDMI and is
part of the HDMI standard. CEC provides interopera-
bility between various components, however, opera-
tion with components other than -compatible
components cannot be guaranteed.
•Set to
“Disable” when a connected piece of equipment
is not compatible or it is unclear whether the equip-
ment is compatible or not.
• If movement is unnatural when set to
“Enable”, change
the setting to
“Disable”.
• Refer to the connected component’s instruction man-
ual for details.
Power Control
To link the power functions of -compatible
components connected via HDMI, select “Enable”.
Notes:
• The
“Power Control” setting can be set only when the
above
“Control” setting is set to “Enable”.
• HDMI power control only works with -com-
patible components that support it and may not work
properly with some components due to their settings
or compatibility.
• When set to “Enable”, power consumption will
increase.
• When set to “Enable”, regardless of whether the AV
receiver is On or on Standby, both audio and video
received by an HDMI input will be output by the
HDMI OUT for playback on the TV or other compo-
nent that’s connected to the HDMI OUT.
• Refer to the connected component’s instruction man-
ual for details.
TV Control
Set to “Enable” when you want to control the AV
receiver from an -compatible TV that is con-
nected to HDMI.
Notes:
•Set to
“Disable” when the TV is not compatible or
when it is unclear whether the TV is compatible or
not.
• The
“TV Control” setting can be set only when the
above
“Control” and “Power Control” settings are both
set to “Enable”.
• Refer to the connected component’s instruction man-
ual for details.
Network
These settings are for use with home automation equip-
ment and external controllers.
Disable: disabled (default).
Enable: enabled.
Disable: Power Control disabled.
Enable: Power Control enabled.
Disable: TV Control disabled.
Enable: TV Control enabled.
Note:
After changing the settings of the “Control”, “Power
Control”
, or “TV Control”, turn off the power to all
connected pieces of equipment and then turn on
again. Refer to the User’s Manuals for all connected
pieces of equipment.