Filter
Top Products
122
Controlling Other Components
You can use the AV receiver’s remote controller
(RC-718M) to control your other AV components,
including those made by other manufacturers. This sec-
tion explains how to:
• Enter the remote control code for a component that
you want to control: DVD, TV, VCR, etc.
• Learn commands directly from another component’s
remote controller (see page 131).
• Program the Macro buttons to perform a sequence of
up to eight remote control actions (see page 132).
The following Remote Mode buttons are prepro-
grammed with remote control codes for controlling the
components listed. You do not need to enter a remote
control code to control these components.
For details on controlling these components, see the
pages indicated.
You’ll need to enter a code for each component that you
want to control.
Note:
The remote control codes provided are correct at the time
of printing, but are subject to change.
Preprogrammed Remote Control
Codes
Integra/Onkyo DVD player (page 125)
Integra/Onkyo CD player (page 128)
Onkyo cassette recorder with (page 130)
Onkyo RI Dock with (page 129)
Entering Remote Control Codes
Remote
Mode
Receiver
Display
Number
buttons
1
Look up the appropriate remote
control code in the separate
Remote Control Codes list.
The codes are organized by category
(e.g., DVD player, TV, etc.).
2
(3 seconds)
While holding down the Remote
Mode button to which you want
to enter a code, press and hold
down the [Display] button (about
3 seconds).
The Remote Mode button lights up.
Notes:
• Remote control codes cannot be
entered for the [Receiver] and
[Zone 2] buttons.
• Only TV remote control codes can be
entered for the [TV] button.
• Apart from the [Receiver], [TV], and
[Zone 2] buttons, remote control
codes from any category can be
entered for the Remote Mode but-
tons. However, these buttons also
work as input selector buttons
(page 54), so choose a Remote Mode
button that corresponds with the
input to which you connect your
component. For example, if you con-
nect your CD player to the CD input,
choose the [CD] button when enter-
ing its remote control code.
3
Within 30 seconds, use the num-
ber buttons to enter the 5-digit
remote control code.
The Remote Mode button flashes
twice.
If the remote control code is not entered
successfully, the Remote Mode button
will flash once slowly.