Onkyo DTR-7.9 Stereo Receiver User Manual


 
113
Advanced Setup—Continued
When an input source is selected, the AV receiver checks
the relevant audio inputs for the presence of an audio sig-
nal and automatically selects an input. With this setting,
you can specify which audio inputs the AV receiver will
check for signals.
Note:
You can select a different option for each input selector.
The digital input signal formats are available only for the
input sources that you have assigned a digital input jack;
otherwise you will see “Analog” indicated on the screen
(see page 44).
Normally, the AV receiver detects the signal format auto-
matically. However, if you experience either of the fol-
lowing issues when playing PCM or DTS material, you
can manually set the signal format to PCM or DTS:
If the beginnings of tracks from a PCM source are cut
off, try setting the format to PCM.
If noise is produced when fast forwarding or reversing
a DTS CD, try setting the format to DTS.
Automatic Audio Input Selection
Setup
1
Press the input selector button
for the input selector whose set-
ting you want to change.
The setting for the Tuner input selector
cannot be changed and is fixed at “Ana-
log”.
2
Press and hold the [Enter] but-
ton.
The current setting is displayed.
3
Press the [Enter] button repeat-
edly to select an option.
HDMIx (Auto):
This option can be selected when an
HDMI input is assigned to an input
selector (see page 42). When this
option is selected, the relevant HDMI,
digital, and analog inputs will be
checked for the presence of an audio
signal. If signals are present at more
than one input, the inputs will be
selected in the following order of prior-
ity: HDMI, digital, analog.
Enter
Input Selector
COAXx (Auto)/OPTx (Auto):
This option can be selected when a dig-
ital input is assigned to an input selec-
tor (see page 44). When this option is
selected, the relevant digital and analog
inputs will be checked for the presence
of an audio signal. If signals are present
at more than one input, the inputs will
be selected in the following order of
priority: digital, analog. Any audio sig-
nals present at the HDMI inputs will
not be output.
Analog:
When this option is selected, the signal
from the relevant analog audio input is
output. Any audio signals present at
HDMI or digital inputs will not be output.
Digital Input Signal Formats
1
Press and hold the AV receiver’s [Enter]
button for about 3 seconds.
2
While “Auto” is displayed (about 3 sec-
onds), use the Left and Right [ ]/[ ] but-
tons to select: PCM, DTS or Auto.
PCM:
Only 2-channel PCM format input signals will be
heard. If the input signal is not PCM, the PCM indi-
cator will flash and noise may also be produced.
DTS:
Only DTS (but not DTS-HD) format input sig-
nals will be heard. If the input signal is not DTS,
the DTS indicator will flash and there will be no
sound.
Auto (default):
The format is detected automatically. If no digital
input signal is present, the corresponding analog
input is used instead.