Filter
Top Products
Remote Control Description
See Figure 3 on page 17
The Home Theater Standard remote control provides on and off, input selection,
processing mode selection, speaker volume and balance adjust, and mute functions, as
well as access to the System Setup and Configuration menu.
To send operational instructions directly into the Home Theater Standard using an RS-
232 based external control device, see RS-232 Port: Sending Commands and
Interpreting Data, the developer’s reference shipped with the Home Theater Standard.
BATTERY INSTALLATION AND REMOVAL
The HTS remote control uses one CR2025 lithium battery, which is included with the
shipment.
To open the battery compartment on the back of the remote control:
1. Place the remote face down on the table.
2. Use your thumbnail or a small jeweler’s or eyeglass screwdriver to move the small
tab toward the center of the remote, while using your index fingernail or screwdriver
to pull down gently on the slot to the right of the tab. The battery compartment will
slide out.
3. Place the battery, plus side up, in the battery tray.
4. Slide battery compartment back into the remote until you hear a click.
The remote control is ready for operation.
Notes
Do not use a knife or other sharp objects to open the battery compartment; they will
scratch the remote control finish.
Replace battery when remote control function becomes intermittent.
Remove battery if the remote control is not used for a long period of time. Battery
leakage can damage the remote control
18
Krell Home Theater Standard