Filter
Top Products
48 Composite Video Inputs
The Home Theater Standard is equipped with four RCA composite video inputs with
RCA connectors.
49 Component Video Outputs
The Home Theater Standard is equipped with one set of component video outputs with
RCA connectors. Component video uses three wires (labeled Y, Cr, and Cb on back
panel) to convey the video signal, including the OSD.
50 Component Video Inputs
The Home Theater Standard is equipped with two sets of component video inputs.
Remote Control
51 RS-232 Remote or Optional PHAST Link Connector
The Home Theater Standard is equipped with an RS-232 port, which receives
messages from a computer based control system, providing more intelligent control of
the Home Theater Standard. For more information, see RS-232 Port: Sending
Commands and Interpreting Data, developer’s reference shipped with the Home
Theater Standard.
The Home Theater Standard may be outfitted with an optional PHAST Link connector
instead of an RS-232 connector, for integrating the HTS within a PHAST system.
Contact your authorized Krell dealer, distributor, or Krell for information about this
connection option.
52 RC-5 In
The RC-5 input makes custom installation easy and secure by accepting baseband
RC-5 input commands from hardwired remote controllers.
53 12 VDC Out and In
The 12 VDC output sends a 12 Volt power on/off signal to other Krell components via a
12 V trigger cable, as well as to other devices that incorporate 12 Volt power on/off
trigger input. The Home Theater Standard has four programmable 12 Volt outputs:
Out1, Out2, Out3, and Out4; one input is available.
Note
When the HTS is in the operational mode, the 12 VDC Out provides 12 V of DC output.
When the HTS is in the stand-by mode or off, the DC output is 0 V.
Power
54 Back Panel Power Switch
Use this switch to change the Home Theater Standard from off to stand-by.
55 lEO Connector
The Home Theater Standard is equipped with a standard female IEC power connector,
for use with the AC power cord.
16 Krell Home Theater Standard