Filter
Top Products
48
EN
Program timer (continued)
7
Press the VOLUME/
MULTI CON-
TROL
UP ( ) or DOWN ( ) key
to select "PLAY" or "AI PLAY",
then press the SET/DEMO key.
"PLAY" : The source will played at the
adjusted volume before entering the
STANDBY mode.
"AI PLAY" : The playback volume will in-
crease gradually after the start of timer
playback.
8
Press the VOLUME/
MULTI CON-
TROL
UP ( ) or DOWN ( ) key
to select the music source to
be input, then press the SET/
DEMO key.
The input source can be selected from
"CD", "MD" and "TUNER" (radio).
9
To listen to radio broadcast-
ing, press the VOLUME/
MULTI
CONTROL
UP ( ) or DOWN ( )
key to select the preset num-
ber of the desired station, then
press the SET/DEMO key.
This operation is not required when an input
source other than "TUNER" is selected.
0
Press the VOLUME/
MULTI CON-
TROL
UP ( ) or DOWN ( ) key
to adjust the listening volume.
The source will be played at the adjusted
volume.
This step is not required when "AI PLAY" is
selected.
7 Execution
!
Press the TIMER key on the
remote repeatedly so that
the program number to be
executed ("PROG.1" or
"PROG. 2") is lit.
@
Press the POWER key to
put the unit in the STANDBY
mode.
When the timer program is activated and
the unit enters the STANDBY mode, the
STANDBY/TIMER indicator lights in green.
When the set ON time comes, the timer
program is executed and playback starts.
Program No.
To cancel program timer :
Press the TIMER key on the remote so that
"PROG.1" and "PROG.2" are not lit.
To check or change the timer setting :
Restart the procedure from step 1 again.
÷ Be sure to adjust the time of the day (page 10)
before using the timer functions.
÷ The program timer cannot be used for program
playback of CD or MD.
÷ PROG.1 and PROG.2 should be set so that their
operating periods do not overlap. Leave at least 1
minute of interval between the two programs.
÷ The program timer setting is held in memory even
after it is canceled. The program timer setting
remains in memory unless it is newly set again.
÷ If the STANDBY/TIMER indicator is blinking in
green, the timer setting may be erroneous or the
time of the day is not adjusted. Re-set the appli-
cable item.