Filter
Top Products
43
5. OSD Setup menu
This menu provides settings for you to customize the on-screen
display (OSD) for the DTR-6.2 by setting different colors or
positions for its display.
Setup menus
Menu
1.Speaker Setup
2.Input Setup
3.Listening Mode Setup
4.Preference
5.OSD Setup
|ENTER| Quit:|OSD|
5.OSD Setup
1.OSD Setup
2.OSD Position
|ENTER|Quit:|SETUP|
5-1. OSD Setup sub-menu
VIDEO 1
5-2. OSD Position sub-menu
This sub-menu allows you to adjust the position of the OSD Setup
menu as it is displayed on your screen. Depending on the monitor
used, there may be cases where the OSD Setup menu is not displayed
in the center and parts of the menus are cut off. To adjust the position
of the OSD Setup menu, simply press the cursor buttons to inch the
menu to position you desire.
Menu
1.Speaker Setup
2.Input Setup
3.Listening Mode Setup
4.Preference
5.OSD Setup
|ENTER| Quit:|OSD|
5.OSD Setup
1.OSD Config
2.OSD Setup
3.OSD Position
|ENTER| Quit:|OSD|
5-2.OSD Position
Quit:|SETUP|
Menu
1.Speaker Setup
2.Input Setup
3.Listening Mode Setup
4.Preference
5.OSD Setup
|ENTER| Quit:|OSD|
5.OSD Setup
1.OSD Config
2.OSD Setup
3.OSD Position
|ENTER| Quit:|OSD|
5-1.OSD Setup
a.Background Color
:Blue1
b.Superimpose Mode
:Normal
c.Immediate Display
:On
d.Display Position
:Bottom
Quit:|SETUP|
c. Immediate Display
On: Select this to have the screen immediately display certain
operations as you perform them. The display will remain for a
few seconds after the operation is completed.
Off: Select this to turn off the immediate display of operations.
Hint:
If this is set to “Off,” the background color will not be displayed
even when there is no video signal input.
d. Display Position
Use this setting to select the position of the immediate display that
appears when certain operations are performed. You can position the
immediate display at any of ten different levels ranging from the top
all the way to the bottom.
This sub-menu allows you to customize the OSD Setup menu to
display in the manner you desire.
a. Background Color
Select either Blue1, Blue2, Green1, Green2, Magenta, Red1, or
Red2 as the background color while the OSD Setup menu is
displayed.
b. Superimpose
Off: Select to have the OSD Setup menu displayed on the
selected background color.
Normal: Select to have the OSD Setup menu superimposed over
the current video if one is displayed or on the selected
background color if there is no video signal.
Black: Select to have the OSD Setup menu displayed on a black
background at all times.