Filter
Top Products
39
Setup menus
2-2. Video Setup sub-menu
Input source selected Component video input
DVD INPUT 1
Video 1 INPUT 2
Video 2 INPUT 1
Video 3 INPUT 1
Video 4 INPUT 1
a. Component Video
If a component is connected to the one of the COMPONENT
VIDEO inputs (1 or 2), then that input must be set here. This setting
will not appear if AM, FM, Phono, CD or Tape is selected as the
input source.
The default settings are given below.
Menu
1.Speaker Setup
2.Input Setup
3.Listening Mode Setup
4.Preference
5.OSD Setup
|ENTER| Quit:|OSD|
2.Input Setup
Input:DVD
a.Audio Setup
b.Video Setup
c.Listening Mode Preset
d.Tone Control
e.IntelliVolume
f.12V Trigger
|ENTER| Quit:|OSD|
2-2.Video Setup
Input:DVD
a.Component Video
:Input1
Quit:|SETUP|
2-2. Video Setup sub-menu 2-3. Listening Mode Preset sub-menu
With the DTR-6.2, you can set a different listening mode for each
different signal type that comes from each input source and also set
the parameters for the listening mode itself. For example, if your
DVD player also plays compact discs and the DVD video signal is
DTS and the compact disc signal is PCM, then you can set a
different listening mode for each.
This is especially convenient if you frequently play the same types
of movies or music.
See the next page for information regarding the relationship
between input sources and listening modes.
Input source signals
a. Analog/PCM Source
Set a listening mode for the input signal from analog sources and
PCM sources.
Note:
For PCM sources recorded at a sampling rate of 96 kHz or greater,
only the Stereo or Direct listening modes can be selected.
However, the set listening mode is stored in memory.
b. Digital Format
Set a listening mode for the input signal from Dolby Digital and
DTS sources.
• The DTR-6.2 will automatically switch to the listening mode
set for the current input signal. For example, even when using
the same DVD player, if a CD is played, the listening mode
automatically becomes “Stereo,” and if a DVD is played
(Dolby Digital 3/2.1), the listening mode automatically
becomes Dolby D.
Menu
1.Speaker Setup
2.Input Setup
3.Listening Mode Setup
4.Preference
5.OSD Setup
|ENTER| Quit:|OSD|
2.Input Setup
Input:DVD
a.Audio Setup
b.Video Setup
c.Listening Mode Preset
d.Tone Control
e.IntelliVolume
f.12V Trigger
|ENTER| QuSD|
2-3.ListeningMode Preset
Input:DVD
a.Analog/PCM Source
:Stereo
b.Digital Format
:Surround
Quit:|SETUP|