Filter
Top Products
20
IR IN
DTR-6.2
In the
cobinet
Remote Controller
Connecting
block
IR Receiver
: Signal flow
IR IN
IR OUT
Connecting
block
IR Receiver
DTR-6.2
IR Emitter
Remote Controller
other
component
: Signal flow
IN
IR
OUT
: Signal flow
IR Emitter
Remote control
sensor
other component
DTR-6.2
Mini plug
Emitter
Mini plug cable
Operating components not reached by the
remote controller signals (IR IN/OUT)
If the remote controller signal does not reach the
DTR-6.2 remote sensor
If the DTR-6.2 is located inside a cabinet or other enclosure where
the infrared rays from the remote controller cannnot enter, then
operation with the remote controller will noe be possible. In such a
case, it will be necessary to install a remote sensor at a location
outside of the cabinet for the infrared rays from the controller to
reach.
With this connection, select “Main” for the Preference → IR IN
Setup → Position setting in the Setup menu (see page 42).
If the remote controller signal does not reach
other components
In this situation, you will need to use a commercially available IR
emitter. Connect the mini plug of the IR emitter to the IR OUT
terminal on the DTR-6.2 and then place the IR emitter on the remote
sensor of the component or facing it. When the IR emitter is
connected, only the signal input to the IR IN terminal is output to the
IR OUT terminal. The signal input from the remote sensor on the
front of the DTR-6.2 will not be output to the IR OUT terminal.
The following equipment (sold separately) is essential for
operation:
• Onkyo’s Multi-Room System kits (IR Remote Controller
Extension System), or
• Multiroom A/V distribution and control systems from Niles
®
and Xantech
®
to name a few
IN
IR
OUT
Mini plug cable
DTR-6.2
The IR IN input allows you to control the DTR-6.2 from the remote
zone (Zone 2) with the remote controller even though the remote
zone is physically separated. The diagram below shows how to make
the proper connections for the remote zone.
With this connection, select “Zone 2” for the Preference → IR IN
Setup → Position setting in the Setup menu (see page 42).
Connecting
block
DTR-6.2
Main room
: Signal flow
To IR IN
Remote room
IR Receiver
Remote controller
Make connection as shown below. Do not plug the equipment into
the power source until the connection is complete.
from connecting block