Filter
Top Products
29
Enjoying music or videos with the DTR-6.2
Though the DTR-6.2 is often used to listen to the radio, it does not
show you its true ability until it is used to play music or watch
videos, DVDs, and the like. The DTR-6.2 has the latest in state-of-
the-art features to play back today’s acoustic technologies with the
utmost in fidelity and power. From a two-speaker system to a five-
speaker system, you are assured a sound space that you can always
enjoy.
Listening with headphones
To listen with headphones, plug a pair headphones with a standard
stereo plug into the Phones jack on the DTR-6.2 front panel.
When you connect headphones, the unit will enter STEREO mode
automatically and no sound will be heard from the speakers.
If you have selected MULTI CH INPUT, you will hear sound only
from the FRONT L and R channels.
The headphone volume level can be adjusted at the Setup menu (see
page 42).
Note that the signal to the remote zone (Zone 2) will not be affected
whether or not headphones are connected.
Adjusting the bass and treble
You can adjust the bass and treble levels using the Bass and Treble
dials. This function only affects the front left and right speakers. For
multichannel sources, these dials will not work if the tone control is
set to “Off.”
Temporarily turning off the sound
To turn off the sound momentarily, such as when interrupted by a
phone call, press the MUTING button on the remote controller.
When pressed, “Muting” is displayed on the DTR-6.2. Press the
MUTING button again to turn the sound back on.
Phones
Bass
Treble
HOME THEATER CONTROLLER
RC
-
441M
Standby/On
Standby
Power
On
O
f
f
Phones
Video 1
Video 3
DVD Video 2
Video 4
Audio
Selector
Bass
Treble
Master Volume
Smart
Scan
Navigator
Rec Out Zone 2 Zone 2 Level
CH Level
DimmerDisplay
Tuning
FM ModePreset Memory
Preset
VCR 1
VCR 2
Tape FM AM Phono CD
Push To Enter
DSP/Mode ADJ
Setup
Return
Master Volume
MUTING
Phones Treble
Bass
VOL
Basic operation
1. Press the input source (or input selector on the
remote controller) button.
Remote controller
2. Turn on the corresponding component and play the
media.
3. Adjust the volume.
FM AM Phono C
DTape
DVD
Video 3 Video 4Video 2Video 1
VCR 2VCR 1
DTR-6.2
Remote controller
Adjusting the main volume adjusts the volume level output from
all the speakers connected to the DTR-6.2 together. If
headphones are connected, this also adjusts the volume heard
from the headphone speakers. To adjust the volume, either press
the VOL
buttons on the remote controller or turn the Master
Volume dial. To increase the volume, turn the dial clockwise; to
decrease the volume, turn the dial counterclockwise. The
volume can be set to Min, 1 to 79, and Max.
INPUT
SELECTOR
buttons
Input source buttons
DTR-6.2 Remote controller
Master Volume