Filter
Top Products
30
Enjoying music or videos with the DTR-6.2
Switching the display
While listening to or watching an input source, you can display the
information regarding the type of source and signal being input by
pressing the
button on the DTR-6.2 or the DISPLAY button on the remote
controller.
When an input source other than FM or AM is selected:
* If the input signal does not have a program format, then this will
be skipped.
Input + volume
Program format*
Input +
Listening mode
or Multi Ch
When FM or AM is selected as the input source:
FM/AM frequency +
Preset no.
FM/AM +
Listening mode
ch
Using the sleep time (remote controller only)
The SLEEP button enables you to set the DTR-6.2 to turn off
automatically after a specified time period. If you press it once, the
DTR-6.2 will turn off after 90 minutes. Each time it is pressed
thereafter, the remaining time until the DTR-6.2 turns off decreases
by 10 minutes. While, the sleep function is enabled, you can press
the SLEEP button to see how much time is left. To cancel the sleep
function, press the SLEEP button when the time displayed is less
than 10 minutes.
If you are using the remote zone (Zone 2), it will turn off at the same
time as the main zone. If you want to set the sleep function for Zone
2 only, set the sleep function with main zone turned on and then put
the main zone into the standby state.
Temporarily changing the speaker output levels
To change the individual speaker volumes temporarily, follow the
procedure given below. Each channel can be set between –12 to +12
decibels. Note that the calibration settings will return to the original
settings when the DTR-6.2 is put in standby.
1. Press the CH Level button and select
the desired speaker.
2. Turn the jog dial to adjust the
volume level.
Display
CH Level
Push To Enter
DSP
/
Mode ADJ
When using the remote controller:
1. Press the RCVR MODE button.
2. Press the CH SEL button and select
the desired speaker.
3. Press the LEVEL or button to
adjust the volume level.
DTR-6.2 Remote controller
MUTING
HOME THEATER CONTROLLER
RC
-
441M
Standby/On
Standby
Power
On
O
f
f
Phones
Video 1
Video 3
DVD Video 2
Video 4
Audio
Selector
Bass
Treble
Master Volume
Smart
Scan
Navigator
Rec Out Zone 2 Zone 2 Level
CH Level
DimmerDisplay
Tuning
FM ModePreset Memory
Preset
VCR 1
VCR 2
Tape FM AM Phono CD
Push To Enter
DSP/Mode ADJ
Setup
Return
CH LevelDisplay Dimmer
SLEEP
LEVEL
DIMMER
CH SEL
DISPLAY
Jog dial
Adjusting the brightness of the front display
You can adjust the brightness of the front display of the DTR-6.2
with DIMMER button on the remote controller or Dimmer button
on the DTR-6.2 front panel.
Dimmer
Remote controller
DTR-6.2 Remote controller
Notes:
• You cannot select a speaker if the Speaker Config sub-menu of
the Speaker Setup is set to No or None.
• If the speaker level is set to +1 dB or higher, the maximum level
indicated on the display will change if you raise the volume
level.
• When you press the TEST button after you set the level, the
current level will be used as the value set via the test tone.